Effect of Pile Geometry on the Interpretation of Pile Integrity Test Results by Numerical Simulation

Document Type : Original Research

Authors
M. Mansoori
E. Seyedi Hosseininia
S. Abrishami
Ferdowsi University of Mashhad
10.22034/24.1.127
Abstract


The most important point in performing the Pile Integrity Test (PIT) is the correct interpretation of the results. This insitu tests is very useful in the estimation of the pile length embedded in the soil or the control of the cross section of bored piled where the quility of the pile construction is in doubt. Two common defects of the bored piles are buldging and necking of the pile cross section which correspond to the over-size and narrowing of the pile diameter alonng the pile length. Thses two anolamies in the pile geometry inflence the pile functionality and an approperiate reaction is required. Correct identifications of the length and dpeth of an anomaly are among the factors that are influenced by the anomaly location and the interaction of the waves passing through the pile. In this research, an attempt is made to interpret the results of PIT by examining the dimensions and location of anomalies in different parts of the pile as well as the effect of the presence of soil on the obtained results. PIT is simulated by the numerical finite difference method and the results have been investigated. The pile head is loaded by a semi-sinusoidal impact which is defined as a compressive pressure over a circular region at the cross section centroid during a short period of time. The verification of the simulations is established by the compariosn of the results with those one-dimentional wave theory which is based on the arrival time of the impact wave to the reciever situated on the pile head. In addition, by changing the position of the wave vreciving in the numenrical mode, it was shown that the best place to install the accelerometer as the recivier would be at the distance of 0.6R from the pile center where R is the pile radius. This finding is consistent with the results of previous studies which confirms the validiy of the simulations. According to the results, the existance of the soil around the pile causes to deform the figure of the waves and it required to modify the records before a correct interpretation. The soil atound the pile plays a role of damper of the waves passing through the pile and it causes that the magnitude of the peaks observed in the records diminish and the interpretaion may not be so easy as that in a free pile. For the pile embeded in the soil, the closer the anomaly location is to the pile head, the less the damping effect of the soil is and thus, the wave forms are more similar to the free pile. Based on the findings of this study, to interprete correctly the PIT results, it is recommended to use the first peak of the recorded velocity if there is a necking defect, while the use of the second peak is recommneded for a buldging defect to estimate the anomaly depth based on the free pile diagrams.It is also seen that as the defect length increases to about twice the diameter of the pile, the peak value of the velocity changes (in most cases, it increases) and remains almost constant at larger lengths.

Keywords

Subjects

1. Smith, E., Pile-driving analysis by the wave equation. Journal of the soil mechanics and foundations division, 1960. 86(4): p. 35-61.
2. Lee, S.L., et al., Rational wave equation Model for pile-driving
analysis. Geotech. Engrg, 1988: p. 306-325.
3. Chai, H.-Y. and K.-K. Phoon, Detection of Shallow Anomalies in Pile Integrity Testing. International Journal of Geomechanics, 2013. 13( 5): p. 672-677.
4. Chai, H.-Y., et al., Some observations on the performance of the signal matching technique in assessment of pile integrity. Journal of nondestructive evaluation, 2011. 30(4): p. 246-258.
5. Huang, Y.-H., et al., Assessment of identifiable defect size in a drilled shaft using sonic echo method: Numerical simulation. Computers and geotechnics, 2010. 37(6): p. 757-768.
6. Chai, H.-Y., et al., Effects of the Source on Wave Propagation in Pile Integrity testing. Journal of geotechnical and geoenvironmental engineering, 2010. 136(9): p. 1200-1208.
7. Chow, Y.K., et al., Low strain integrity testing of piles: three-dimensional effects. Journal of geotechnical and geoenvironmental engineering, 2003. 129(11): p. 1057-1062.
8. Steinbach, J. and E. Vey, Caisson evaluation by stress wave propagation method. Journal of Geotechnical and Geoenvironmental Engineering, 1975. 101(ASCE# 11234 Proceeding).
9. Smith, I. and Y. Chow. Three dimensional analysis of pile drivability. in Proc. 2nd Int. Conf. on Numerical Methods in Offshore Piling, Austin, Texas. 1982.
10. Fukuhara, T., M. Kakurai, and M. Sugimoto. Analytical evaluation of defective piles. in Proceedings of the 4th International Conference on the Application of Stress-Wave Theory to Piles. 1992.
11. Liao, S.T. and J.M. Roesset, Dynamic response of intact piles to impulse loads. International Journal for Numerical and Analytical Methods in Geomechanics, 1997. 21(4): p. 255-275.
12. Jiang, J., et al., A study on low strain integrity testing of platform-pile system using staggered grid finite difference method. Soil dynamics and earthquake engineering, 2014. 67: p. 345–352.
13. Zheng, C., et al., Three-dimensional effects in low-strain integrity testing of piles: analytical solution. Canadian geotechnical Journal, 2015. 53(2): p. 225-235.
14. Zheng, c., et al., Non-axisymmetric response of piles in low-strain integrity testing. Géotechnique, 2016. 67(2): p. 181-186.
15. Liu, X., et al., Theoretical analysis of three-dimensional effect in pile integrity test. Computers and Geotechnics, 2020. 127: p. 103765.
16. Liu, X., et al., A simplified non-axisymmetric pile-soil interaction model for pile integrity testing analysis. Applied Mathematical Modelling, 2023. 119: p. 137-155.
17. Protopapadakis, E., et al., A genetically optimized neural classifier applied to numerical pile integrity tests considering concrete piles. Computers & Structures, 2016. 162: p. 68-79.
18. Liu, X., et al., Dynamic analysis of layered soil-pile interaction based on the nearly continuous model. Ocean Engineering, 2023. 279: p. 114457.
19. Wong, k.y., Small strain sonic pile test-need for caution. Ground engineering, 1995. 28(9): p. 32-37.
20. K., F. and A. I.H., Appication of PIT in the estimation of pile lengths in posts 10 and 14 of Imam Khomeini Port, in Proceedings of 9th International Conference on Coasts, Ports and Marine Structures (ICOPMAS). 2010: Tehran, Iran.
21. Ni, S.-H., et al., Low-strain integrity testing of drilled piles with high slenderness ratio. Computers and geotechnics, 2006. 33(6-7): p. 283-293.
22. Forehand, P.W. and J.L. Reese, Pile driving analysis using the wave equation. 1963, Princeton University.
23. D5882-07., A., Standard Test Method for Low Strain Impact Integrity Testing of Deep Foundations. 2007, American Society for Testing and Materials (ASTM International ….
24. Cosic, M., B. Folic, and R. Folic, Numerical simulation of the pile integrity test on defected piles. Acta Geotechnica Slovenica, 2014. 11(2): p. 5-19.
25. Kuhlemeyer, R.L. and L. J., Finite Element Method Accuracy for Wave Propagation Problems Journal of the Soil Mechanics and Foundations Division, 1973. 99(5): p. 421-427.
26. Cundall, P., FLAC 3D Manual: a computer program for fast Lagrangian analysis of continua (Version 4.0). Minneapolis, Minnesota, USA, 2008.
27. Ding, X., et al., Wave propagation in a pipe pile for low-strain integrity testing. Journal of Engineering Mechanics, 2011. 137(9): p. 598-609.
28. Kokusho, T., Y. Yoshida, and Y. Esashi, Dynamic properties of soft clay for wide strain range. Soils and Foundations, 1982. 22(4): p. 1-18.
29. Chen, W.-F. and A.F. Saleeb, Constitutive equations for engineering materials: Elasticity and modeling. 2013: Elsevier.
30. Iran, P.a.B.O.o., Iranian Concrete Code (ABA), in Standard 120. 2022, Planning and Budget Organization of Iran.
31. Chan, H.-F.C., Non-Destructive Testing of Concrete Piles using the Sonic Echo and Transient Shock Methods. 1987, University of Edinburgh.
32. Chow, Y., et al., Low strain integrity testing of piles: Three-dimensional effects. Journal of Geotechnical and Geoenvironmental Engineering, 2003. 129(11): p. 1057-1062.
33. Davies, R., A critical study of the Hopkinson pressure bar. Philosophical Transactions of the Royal Society of London. Series A, Mathematical and Physical Sciences, 1948. 240(821): p. 375-457.
34. Ding, X., et al., Vertical dynamic response of a concrete filled steel tube due to transient impact load: analytical solution. International Journal of Structural Stability and Dynamics, 2016. 16(01): p. 1640014.
35. Fischer, J., et al., Numerical simulation of low-strain integrity tests on model piles, in Numerical Methods in Geotechnical engineering. 2010, CRC Press. p. 671-676.
36. Kolsky, H., An investigation of the mechanical properties of materials at very high rates of loading. Proceedings of the physical society. Section B, 1949. 62(11): p. 676.
37. Mansoori, M., Numerical simulation of pile integrity test (PIT) 1398, Ferdowsi University of Mashhad.
Modares Civil Engineering journal
Volume 24, Issue 1
March and April 2024
Pages 127-140