Investigation of the slope behavior of saturated sands in drainage condition and over time–experimental and numerical study

Document Type : Original Research

Authors
M. Kavosi 1
M. Hajiazizi 2
M. Nasiri 1
1 Razi University
2 Razi University/Civil Eng
Abstract
Time-dependent behavior in soils causes mechanical, chemical, and geo-mechanical changes. This behavior in soils considers as a major challenge in geotechnical engineering, and yet need more attentions. The impact of time on geo-materials and their behavior such as rock and soils are undeniable. Based on researches previously performed on this issue, the importance of time-dependent behavior emerged. Creep (strain deformation under constant stress level), stress relaxation (stress deformation under constant strain level), and loading pace are among time-dependent special features, which are seen in experimental models. Creep divided in three categories: primary creep, in which rate of deformation reduced with time. This creep starts immediately after loading procedure. Secondary creep in which rate of deformation is constant. Finally, tertiary creep in which rate of deformation increased and at last material failed. In this research, the effect of time on the stability of the saturated sand has been investigated by building a small-scale experimental model and using finite element numerical method. Preparation of the sand slope was using sand downfall and the saturation process of the experimental models are carried out artificially with a flow rate of 1 liter per minute. Due to the friction angle of the sand, two physical models were created with slope angle of 35 degrees and 37 degrees. The results of physical modeling showed that drainage in sandy slopes, despite stability in non-drainage conditions, gradually increases the deformation in the slope so that over time it will cause failure in the slope. The results of physical modeling showed that in the first model, the maximum horizontal and vertical displacements are 10.5 and 9 cm, respectively. For the second model, these values ​​are 10.5 and 7 cm, in order. At the end of this research, statistical analyzes have been used to provide relationships for predicting vertical settlement in saturated sand slopes. Using numerical models with dimension analysis rules (make the dimensions 100 times in numerical models), in first model in order to reach 8.81 meter displacements, 3780 minutes of raining needed. While in second model, for reaching 7.20 meter displacement, 2280 minutes needed. Results indicate that by increasing cohesion, vertical displacement decrease. As friction angle increase, vertical displacement also decreases. While by increasing slope angle, vertical displacement increase. At the end of this study, statistical analysis has been used to provide relationships to predict the amount of vertical displacement in the slope crown, which is the maximum amount of displacement in the slope.

Keywords

Subjects

[1] Augustesen, A., Liingaard, M. and Lade, P.V. 2004. Evaluation of Time-Dependent Behavior of Soils, International journal of Geomechanics (ASCE), 4(3), 137-156.
[2] Koenzen J.P. 1977. Time-Dependent Stress-Strain Behavior of Silicate-Grouted Sand. Journal of the Geotechnical Engineering Division, 103(8), 903-908.
[3] Lade P.V. 1994. Creep effects on static and cyclic instability of granular soils. Journal of Geotechnical Engineering, 120(2), 404-419.
[4] Carrubba P., & Del Fabbro, M. 2008. Laboratory investigation on reactivated residual strength. Journal of Geotechnical and Geoenvironmental Engineering, 134(3), 302-315.
[5] Bhat D.R., Yatabe R., & Bhandary N.P. 2014. Strength Recovery of Landslide Soils from the Residual State of Shear. Soil Behavior and Geomechanics, ASCE, 254-264.
[6] Zhao Z., & Song E.X. 2015. Particle mechanics modeling of creep behavior of rockfill materials under dry and wet conditions. Computers and Geotechnics, 68, 137-146.
[7] Li L., Li J., Sun D., & Gong W. 2016. Analysis of Time-Dependent Bearing Capacity of a Driven Pile in clayey soils by total stress method. International Journal of Geomechanics, ASCE.
[9] Wang G. 2009. Consolidation of Soft clay foundations reinforced by stone columns under time-dependent loading. Journal of Geotechnical and Geoenvironmental Engineering, ASCE, 135, 1992-1931.
[10] Ho L., & Fatahi B. 2015. One-dimensional consolidation analysis of unsaturated soils subjected to time-dependent loading. International journal of geomechanics, ASCE.
[11] Powell J.S., Take W.A., Siemens G., & Remenda V.H. 2012. Time-dependent behavior of the bearpaw shale in oedometric loading and unloading. Canadian Geotechnical Journal, 49, 427-441.
[12] Yin J.H., & Zhu J.G. 1999. Measured and predicted time-dependent stress-strain behavior of Hong Kong marine deposits. Canadian Geotechnical Journal, 36, 760-766.
[13] Pramthawee P., Jongpradist P., & Sukkarak R. 2017. Integration of creep into a modified hardening soil model for time-dependent analysis of a high rockfill dam. Computers and Geotechnics, 91, 104-116.
[14] Olibeira P.J.V., Correia A.A.S., & Lemos L.J.L. 2017. Numerical prediction of the creep behavior of an unstabilised and chemically stabilised soft soil. Computers and Geotechnics, 87, 20-31.
[15] Wu L.Z., Zhou Y., Sun P., Shi J.S., Liu G.G., & Bai L.Y. 2017. Laboratory characterization of rainfall-induced loess slope failure. Catena, 150, 1-8.
[17] Regmi R.K., Jung K., Nakagawa H., Do X.K., & Mishra B.K. 2017. Numerical analysis of multiple slope failure due to rainfall: Based on laboratory experiments. Catena, 150, 173-191.
[18] Kristo C., Rahardjo H., & Satyanaga A. 2017. Effect of variations in rainfall intensity on slope stability in Singapore. International Soil and Water Conservation Research, 5(4), 258-264.
[19] Liu Q.Q., & Li J.C. 2015. Effects of water seepage on the stability of soil-slopes. Procedia IUTAM, 17, 29-39.
[20] Mahmoodi H., Farogh Hossieini M., Ahmadi M., & Jalali M. 2010. Studying the effect of weight on Time- Dependent Behavior of Gotvand dam Foundation. Modares Civil Engineering Journal (M.C.E.J.), 10(2), (In Persian).
[21] Jafarian Y., & Lashgari A. 2017. Effect of slip width on the permanent displacement of earth slopes. AmirKabir Journal of Science & Research Civil and Environmental Engineering (ASJR-CEE), 49(1), 81-87, (In Persian).
[22] Hajiazizi M., & Bavali, M. & Fakhimi, A. 2018. Numerical and Experimental Study of the Optimal Location of Concrete Piles in a Saturated Sandy Slope. Int. J. of Civil Engineering 16, 1293-1301.
[23] Novak P., Moffat A., & Nalluri C. 1990. Hydraluic Structures. Pitman. London. p. 546.
[24] Wood D.M. 2004. Geotechnical Modeling. CRC Press.
[25] Vesic A.S. 1973. Analysis of ultimate loads of shallow foundations. Soil Mechanics and Foundation. 99(1), 45-73.
[26] El Sawwaf M.A. 2005. Strip footing behavior on pile and sheet pile-stabilized sand slope. Journal of Geotechnical and Geoenvironmental Engineering, 131(6), 705-715.
[27] Hegde A.M., & Sitharam T.G. 2015. Experimental and numerical studies on protection of buried pipelines and underground utilities using geocells. Geotextiles and Geomembranes, 43(5), 372-381.
[28] Fakher A., & Jones C.J.F.P. 1996. Discussion on bearing capacity of rectangular footings on geogrid reinforced sand by Yetimoglu. T, Wu. J. T. H, Saglamer. A, 1994. Journal of Geotechnical Engineering, 122, 326-327.
Modares Civil Engineering journal
Volume 21, Issue 5
November and December 2021
Pages 15-28