Investigation of the process of water leakage using discrete fracture network method (Case Study: Gardaneh rokh tunnel)

Document Type : Original Research

Authors
E. Malekipoor 1
E. Emami 1
M. Moshrefyfar 1
R. Ajalloeian 2
1 yazd university
2 Esfahan university
Abstract
Undoubtedly, fluid flow modeling plays an important role in underground structures studies. In many cases, the main system for fluid flow in rock mass is the fractures network. Because of that the measurement of the geometric properties of the discontinuities is a time-consuming process and for some properties like persistence is impossible, the use of stochastic modeling for rock mass is suggested. Uncertainty about the geometric properties of discontinuities has led to use of statistical analysis for more accurately define geometric features. Because of intrinsic statistical nature of the geometric features of discontinuities, a more precise model can be obtained from the development of stochastic three-dimensional geometric models of discontinuities. The most important step in rock mass modeling is the exact definition of the discontinuity network. This makes it possible to provide a better starting point for numerical modeling in mechanical and hydraulic analysis. The Gardaneh-Rokh tunnel with a length of 1300 meters and a maximum volume of 200 meters is located in Chaharmahal Bakhtiary province. The purpose of this study was to investigate the water leakage from joints and fractures in the tunnel and the effect of surface water in the amount of water leakage into the tunnel using analytical and numerical methods. This modeling has been done to increase the understanding of the hydraulic behavior of the massive discontinuity system. In this study, the fractures connected to each other as the main paths of water flow into the tunnel and the control of the hydraulic behavior of the mass are assumed, and the roughness of the joints is neglected To this paper, joint sets in Gagrdaneh Rokh tunnel was modeled using the 3D-DFN code written in the Mathemtica software, after validation of the surveyed and modeled values, it was observed that the percentage of conformance is above 85%. This has led to the use of model outputs with confidence in the hydraulic modeling of the tunnel. This paper is designed with the aim of two-dimensional hydraulic modeling in the UDEC software environment. The modeling fluid is considered as monophasic, and discontinuities are modeled as two-dimensional. Hydraulic modeling is done by calling the joints from the 3D-DFN program output. Comparison of the obtained results shows good matching between the flow rate in the model with the actual flow rate. The resulting total flow rate is estimated to be 362 liters per minute, which is actually set at 375 liters per minute, which is a good match. Also, the sensitivity analysis of fluid flow has been investigated with respect to the maximum and minimum values of apertures, continuity (trace length) and Fisher numbers. With an opening of 5 mm, the water rate to the tunnel will reach 530 liters per minute. This rate is reduced to 172 liters per minute at opening of 1.2mm. The flow rate arrives in continuity of 27 meters to 523 liters per minute, in a trace length of 22 meters to 488 liters per minute and in trace length of 10 meters to 354 liters per minute. The flow rate in Fisher's number is reduced to 410 liters per minute and in Fisher's number 25 to 290 liters per minute.

Keywords

Subjects

- منابع

[1] Rapantova, N., Grmela, A., Vojtec, D., Halir, J., Michalek, B., 2007,"Ground Water Flow Modelling Applications in Mining Hydrogeology", Mine Water Environ., 26, 264.270.
[2] Eaton, T., T., 2006. "On the importance of geological heterogeneity for flow simulation", Sedimentary Geology, 184, 187.201.
[3] Neuman S P. Trends,2005, "prospects and challenges in quantifying flow and transport through fractured rocks, Hydrogeol", J., 13, pp. 124–147.
[4] Snow, D. T., 1969. "Anisotropic permeability of fractured media", Water Resour. Res.5(6), 1273-1289.
[5] Zhou, Q., Salve, R., Liu, H., Wang, J. S. Y., Hudson, D., 2006. "Analysis of a mesoscale infiltration and water seepage test in unsaturated fractured rock: Spatial variabilities and discrete fracture patterns", Journal of Contaminant Hydrology, 87, 96.122.
[6] Xu, C., Dowd, P. A., Mardia, K. V., Fowell, R. J., 2006. "A Connectivity Index for Discrete Fracture Networks", Mathematical Geology, 38(5), 611-634.
[7] Gahrue bajgirani F., Emami Meybodi E., Mehrnahad H., 2018, “Geometric Modeling of Joints in 3D Discrete Fracture Network (Case Study: Liroo Dam construction site)”, Scientific quarterly journal of Iranian association of engineering geology, Volume 11, Issue 3, pages 29-46.
[8] Adler, P., Thovert, J., 1999. "Fractures and fracture network.", Kluwer academic Publisher, Dordrecht. 428 P.
[9] Priest S D., 2012, "Discontinuity analysis for rock engineering", Springer Science & Business Media; Dec 6.
[10] De Dreuzy J R, Mèheust Y, and Pichot G., 2012 "Influence of fracture scale heterogeneity on the flow properties of three-dimensional discrete fracture networks (DFN)", J. Geophys. Resid. Sol. Earth, 117, B11207.
[11] Painter S, and Cvetkovic V., 2005, "Upscaling discrete fracture network simulations: An alternative to continuum transport models", Water Resour. Res., 41, W02002.
[12] Veneziano, D., 1978, "Probabilistic models of joints in rock. Research report", Department of Civil and Environmental Engineering, Massachusetts Institute of Technology, Cambridge.
[13] Hudson, J. A., & LaPointe, P. R., 1980, "Printed Circuits for Studying Rock Mass Permeability,"International journal of rock mechanics and mining sciences and geomechanics abstracts", Technical Note, 17(5), 297-301,1980.
[14] Zhang. F,. Zhou. Z,. Huang. Y, and. Chen. Z,2004, "Determining the permeability of fractured rocks based on joint mapping," Ground Water, vol. 42, no. 4, p. 509.
[15] Indraratna, B., Ranjith, P. G., & Gale, W. (1999). Single Phase Water Flow Through Rock Fractures. Geotechnical & Geological Engineering, 17(3-4), 211-240. http://dx.doi.org/10.1023/A:1008922417511.
[16] Gattinoni, P., Scesi, L., & Terrana, S. 2009. "Water Flow in Fractured Rock Masses: Numerical Modeling for Tunnel Inflow Assessment", EGU General Assembly Conference Abstracts (pp. 468). Bibliographic Code:2009EGUGA..11..468G.
[17] Ren, F. Ma, G., Fan, L., Wang, Y., Zhu, H., 2017. " Equivalent discrete fracture networks for modelling fluid flow in highly fractured rock mass", International Journal of Engineering Geology. doi: 10.1016/j.enggeo.2017.09.013
[18] Sharifzadeh. M. , Kargar. S., Torabi. A., 1385, "Hydraulic-mechanical analysis of masses around the tunnel using a separate element method", Seventh Iranian Tunnel Conference, Tehran, Iran Tunnel Association, sharif university, (In Persion).
[19] Javadi Stahbani. M., Sharifzadeh.M., 1393, "Modeling fluid flow in a discontinuous medium using a separate fracture network", Sharif Civil Engineering Journal, Volume 2-20, number 3, page 107-116, (In Persion).
[20] Mohagerani, S., Jalali, M., Torabi, R., Frohandeh, F. 2017a. "Application of an Optimal Meshing Method for Analyzing Flow Flow in a Separate Fraction NetworkThree-dimensional ", 2nd.International Conference on Civil Engineering, Architecture and Urban Design 31 Aug., Kasem Bundit University, Bangkok, Thailand.
[21] Witherspoon, P.A., Wang, J.S.Y., Iwai, K., Gale, J.E., 1980,"Validity of cubic law for fluid flow in a deformable rock fracture", Water Resources Research 16(6), 1016.1024.
[22] Rouleau, A., Gale, J.E., 1987. ."Stochastic Discrete Fracture Simulation of Groundwater Flow into an Underground Excavation in Granite"., International Journal of Rock Mechanics and Mining Science & Geomechanics Abstracts 24 (2), 99-112.

[23] Barinde Consulting Engineers,1385, "Second Phase Studies at the Tunnel of Gardaneh Rokh Tunnel", Road and Transportation Directorate of Chaharmahal & Bakhtiari Province, (In Persion).
[24] Fisher, R. A., 1953, "Dispersion on a sphere" Proc. Roy. Soc. London, Ser. A, 217: 295-305.
[25] Dershowitz, W. S., Herda, H. H. 1992. "Interpretation of fracture spacing and intensity". In: Proceedings of 33rd US Symposium on Rock Mechanics. Rotterdam: Balkema; p. 757–766.
Modares Civil Engineering journal
Volume 20, Issue 1
March and April 2020
Pages 147-159