Study of Scale Effect of Piled Raft Foundations in sand under compression load

Document Type : Original Research

Authors
M. Sharafkhah 1
I. SHOOSHPASHA 2
1 PhD candidate, Faculty of Civil Engineering, Babol Noshirvani University of Technology, Babol, Mazandaran, Iran
2 Associate professor , Faculty of Civil Engineering, Babol Noshirvani University of Technology, Babol, Mazandaran, Iran
Abstract
Raft foundations usually have a high bearing capacity in sand, but the amount of settlement limit the allowable bearing pressure. Nowadays, the employment of piled rafts foundations as a solution for decrease of settlement is common. In such cases, the raft usually carries a high portion of structural loading, and the piles are as the settlement reducer elements. The number of piles and their configuration are determined that settlement of the foundation decreases to an allowable value. In these situations, the configuration of piles is determined in optional manner and strategically. In a piled raft foundation, pile-soil-raft interaction is complicated. Although several numerical studies have been carried out to analyze the behaviors of piled raft foundations, very few experimental studies are reported in the literature. This paper concentrates on study of behavior of piled raft in sand by physical modeling and finite element analysis method. The piles and raft models were made of cast-cast-in-place concrete. The physical models consisted of single pile, single pile in group, unpiled raft and piled raft foundation. The size effects of the models were investigated. The results showed that with installation of the single pile in the group, the pile bearing capacity and stiffness increase. Due to increase of the number of piles beneath the raft, the bearing capacity of raft increase and its settlement decrease, significantly. With the use of finite element method and the critical state theory, one can predicate behavior of test model in the full scale dimensions.

Keywords

Subjects

[1] Reul, O. and M.F. Randolph. 2004. “Design Strategies for Piled Rafts Subjected to Nonuniform Vertical Loading”, Journal of Geotechnical and Geoenvironmental Engineering: 1-13.
[2] Alnuaim, A.M.;, El Naggar, H. and El Naggar, A.M. 2017. “Evaluation of Piled Raft Performance Using a Verified 3D Nonlinear Numerical Model”, Geotechnical and Geological Engineering, 35(4): 1831-1845.
[3] Comodromos, E.M., M.C. Papadopoulou and L. Laloui. 2016. “Contribution to the Design Methodologies of Piled Raft Foundations under Combined Loadings”, Canadian Geotechnical Journal, 53(4): 559-577.
[4] Dung, N.T., S.G. Chung and S.R. Kim. 2010. “Settlement of Piled Foundations Using Equevalent Raft Approach”, Proceeding of the Institution of Civil Engineers-Geotechnical Engineering, 163(2): 65-81.
[5] Huangab, M., Y. Jiu, J. Jiang and B. Lie. 2017. “Nonlinear Analysis of Flexible Piled Raft Foundations subjected to Vertical Loads in Layered Soils”, Soils and Foundations, 57(4): 632-644.
[6] Oh, E.Y.N., M. Huang, C. Surarak , R. Adamec and A.S. Balasurbamaniam. 2008. “Finite Element Modeling for Piled Raft Foundation in Sand”, Eleventh East Asia-Pacific Conference on Structure Engineering & Construction, TAIWAN, 19-21.
[7] Raut, J.M., S.R. Khadeshwar, S.P. Bajad and M.S. Kadu. 2014. “Simplified Design Method for Piled Raft Foundations”, Advances in Soil Dynamics and Foundation Engineering: 462-471.
[8] Patil, J., S. A. Vasanwala and C.H. Solanki. 2016. “An Experimental Study of Eccentrically Loaded Piled Raft”, International Journal of Geotechnical Engineering, 9(1) p. p. 101-112.
[9] Lee, S.H. and C.K. Chung. 2005. “An Experimental Study of the Interaction of Vertically Loaded Pile Groups in Sand”, Canadian Geotechnical Journal, 42(5): 1485-1493.
[10] Fioravante, V. and D. Giretti. 2010. “Contact versus Noncontact Piled Raft Foundations”, Canadian Geotechnical Journal, 47(11): 1271-1287.
[11] EI Sawwaf, M. 2010. “Experimental Study of Eccentrically Loaded Raft with Connected and Unconnected Short Piles”, Journal of Geotechnical and Geoenvironmental Engineering, 136(10): 1394-1402.
[12] El-Garhy, B., A.A. Galil, A. Youssef and M.A. Raia. 2013. “Behavior of Raft on Settlement Reducing Piles: Experimental Model Study”, Journal of Rock Mechanics and Geotechnical Engineering, 5(5): 389-399.
[13] Bazyar, M.H., A. Ghorbani and R. Katzenbach. 2009. “Small-Scale Model Test and Three-Dimensional Analysis of Pile-Raft Foundation on Medium-Dense Sand”, International Journal of Civil Engineering, 7(3): 170-175.
[14] Sedran, G., D.F.E. Stolle and R.G. Horvath. 2001.“An Investigation of Scaling and Dimensional Analysis of Axially Loaded Piles”, Canadian Geotechnical Journal, 38(3): 530-541.
[15] Tagaya, K., R.F. Scott and H. Aboshi. 1988. “Scale Effect in Anchor Pullout Test by Centrifugal Technique”, Soil and Foundations, 28(3): 1-12.
[16] Altaee, A. and B.H. Fellenius. 1994. “Physical Modeling in Sand”, Canadian Geotechnical Journal, 31(3): 420-431.
[17] Tomlinson, M.J. 2004. “Pile Design and Construction Practice”: 4nd Edition, E & FN Spon.
[18] Prakash, S.; and Sharma, H.D.; Pile Foundations in Engineering Practice, John Wiley & Sons, 1990.
[19] Poulos, H.G. and E.H. Davis. 1980. Pile Foundation Analysis and Design: John Wiley & Sons, New York.
Modares Civil Engineering journal
Volume 20, Issue 1
March and April 2020
Pages 105-119