Volume 14, Issue 4 (2015)                   IQBQ 2015, 14(4): 159-169 | Back to browse issues page

XML Persian Abstract Print

Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

URL: http://journals.modares.ac.ir/article-16-8965-en.html
Researcher, International Institute of Earthquake Engineering
Abstract:   (3146 Views)
Reinforced concrete buildings are considered as one of the most important types of structures. According to the implementation nature of these buildings, mainly as in place construction, usually their connections are performed as fixed connections. Because of restraint form of girder-column connection in the reinforced concrete buildings, their participation in the lateral load bearing will be in the form of moment frame system. Nowadays stair -column connection in the middle of story is considered as one of the design and implementation problems. Since using of multiple arm stairs is the best method in terms of performance, cost and safety to make an appropriate connection between stories, different methods will be used to transfer landing plate (stations) load to structural members in order to increase stability and safety of the stairs. Two general methods of landing plate load transfer include: A) transfer of stations load to lower or upper balanced beam of the floor B) transfer of stations load to columns around the stair. In our country more attention is paid to the second method (B) due to the ease of implementation and financial and time savings. Fixed and unchangeable behavior of landing plate- column connections in the middle of story is one of the most important properties of a good connection. This target can be achieved largely through designing and implementing of joint connections of landing plates to columns. It is a long time that this connection is designed in our country as joint connection but there are no appropriate details of implementation for the given assumptions. Always in the typical methods there is a considerable moment imposed on the column because of restraint nature of in place reinforced concrete practice. It is clear that this unusual beam – column connection in the middle of story is considered practically an obvious weakness for these columns and the whole structure in terms of loading and final variable behaviors of several columns connected to half-height slab of the stairs.  Purpose of the present study is to introduce a new joint connection that is consistent with national building regulations, part 9 and also can be easily performed and designed. Suggested connection with a shear – friction function can be applied in the connection of slab stairs in the middle of the story to columns. It can also be considered as a suitable method for consistent relationship of design and implementation. Force transmission in this connection is just in a shear form (because moment arm is not formed) and mainly takes place by reinforcement bars. Although concrete connection friction can transmit substantial shear force; it is recommended to ignore this capacity. However, friction connection capacity is predictable and applicable in the theoretical relationships. Implementation of this connection is very simple and can be created just by preparation of several bars as antennae (dowel) with appropriate and minimum aanchorage length. Implementation of suggested connection leads to removal of the beam in the middle of the story staircase. Finally, it causes high amount of savings in the use of concrete, bars and shuttering and increases the accuracy and speed of implementation. According to loading of each staircase, amount of required reinforcement will be calculated based on shear force as well as tensile force.       
Keywords: --
Full-Text [PDF 1224 kb]   (8163 Downloads)    

Received: 2015/03/1 | Accepted: 2015/03/1 | Published: 2015/02/20

Add your comments about this article : Your username or Email:
Write the security code in the box