Volume 10, Issue 4 (2010)
MCEJ 2010, 10(4): 25-32 |
Back to browse issues page
Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
Goddossi1 P, sherzadi A. Effect of Restraint in Plastic Shrinkage and Settlement of
Repair Materials Based on Self-consolidating Concrete. MCEJ 2010; 10 (4) :25-32
URL: http://mcej.modares.ac.ir/article-16-4852-en.html
URL: http://mcej.modares.ac.ir/article-16-4852-en.html
Abstract: (9298 Views)
Plastic shrinkage occurs in fresh concrete within few hours after mixing the concrete. When
the plastic concrete is allowed to shrink freely, it never cracks. But, generally, removal of
unsound material or damaged concrete is a part of repair operation. Thus usually the surface
of the substrate is rough, the repair concrete will be under restrained condition, which will
result in the development of tensile stresses in the plastic concrete and will create cracks on
the surface of the concrete. Four types of repair materials were used in this work: plane selfconsolidating
concrete (SSC), SCC containing silica fume (S.F.), SCC containing S.F. and
latex (Styrene Butadiene Rubber), and SCC containing S.F., latex and fiber. To roughen the
surface of the substrate base, dents with different degree, referring to restraint indices, RI,
were used to provide restraints. RI is defined as the ratio of the surface area dents to smooth
surface area of the slab. The panels were subjected to sever combination of wind, temperature
and relative humidity. The test program includes: settlement strains, free and restrained
shrinkage strains, evaporation and bleeding rates, and cracks characteristic measurements.
The results showed that, while the rate of evaporation and bleeding affected the shrinkage
properties, it was over shadowed by properties of the repair materials and restraints indices.
The results also indicated that, for a given repair concrete, the restrained strain increased as
the R.I. increased. A significant improve was observed for the SCC with latex and fiber,
exhibiting the lowest plastic settlement, shrinkage strains and crack area, and the highest time
to the first crack. The plane SCC exhibited almost two times of higher settlement and
shrinkage strains than the SCC with latex and fiber, for a given R
Received: 2010/03/6 | Accepted: 2010/09/29 | Published: 2011/03/2
| Rights and permissions | |
 |
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License. |